Installation instructions for the Ducati Monster Box Slider KitThese have been designed frame sliders to provide unprecedented protection for model Multistrada S2R, S4R, 600/620/900/1000, in the unfortunate situation of lowside or more than one party. Kits are designed Motovation slider under the protection and manufactured by the company that makes frame sliders only. Are tested each model for the low and the protection of the slides. It is tough but not brittle and can also absorb a significant impact.
Please read all instructions before starting work! The aim of the sliders to fit the engine under specific mounts from your bike. It is strongly recommended to refer to the service before performing this installation. If you are unsure about the tightening torque, and verification of the Guide to your motorcycle or www.motovationusa.com / torque.html for a quick reference guide.
Included in this group:2 sliders frame X with the inclusion of aluminum1 × 10mm stainless steel threaded rods2 × locknuts, washers
Tools required:Key determination2 × 17mm deep socketsDrive RachetInstructions:1) Make sure that the bike is to stand up and vertical, and make sure that drive is supported from below by the masses.2) Remove the rubber plugs covering the points left and right mounting as we have seen in the picture above.3) reduce and remove the nut on the right side (right as he was sitting on the bike). You may have to secure the left side with a socket wrench to do so.4) grip strength threaded rod supplied in the center with pliers or vice versa, in addition to a washing machine, stainless steel and install the supplied tie until the exposed threads started 6-8.
5) from the right side, install a shorter scroll in the frame and insert a rod threaded through the slider until the bolt meets engine factory. Use a rubber mallet, gently push the bolt is very outside the factory by using the supplied threaded rod. It should come out very easily. Do not use excessive force and this may lead to damage to the bar on submissions. If it does not come easily, you may have to reduce subsidies for engine blocks a little bit.
6) Once the motivation behind the bolt out of the factory and provided threaded rod is protruding out from the left side, install the slider is left with a bundle of supplying and washing machine. May be necessary to loosen or tighten nuts to make sure of being almost an equal amount of threads on each side. Tighten the nuts according to manufacturer specifications.
No comments:
Post a Comment